| Blistered DLG Servo Cover Specification | |
|---|---|
| Thickness of carbon sheet | 0.2 mm |
| Chordwise length | 60 mm |
| Spanwise length | 62 mm |
| Distance of blister from edge | 21 mm |
| Width of blister | 6 mm |
| Height of blister | 3 mm |
| Weight | 0.8 g each |
Comment by: Kev
Blistered servo coverDoes the job perfectly not cheap but puts a nice touch and finish to the wing servos.
I would definitely use again, needed some trimming as expected but the fit was perfect when finished, used canopy glue to fix them down.
Review by: Anonymous
The Blistered DLG Servo Covers are as described and good quality
Review by: Brett
Blistered DLG servo coversExcellent wing servo covers that are just right for tight streamlined installations with short servo arms. Items can be cut to size easily. As always, fast and well-packaged service from Hyperflight.
Review by: Roger Sanders
These servo covers are very thin and very light. They can easily be cut with scissors or on a paper cutting board (recommended for accuracy). They are well-made.
However, I found the blister to be too small. I could not get sufficient clearance under the blister for even the smallest servo arm on a micro-sized servo. So I could not use them.
In fairness, I will point out that the wings on my glider are very thin, so the servo arm on even the smallest, 8mm thick servo, extended well past the surface of the wing. If your glider has a thicker wing, the servo arm will not stick out as far and in that case, this servo cover should work fine. But in most cases, I think it would be advisable to get a servo cover that has a larger blister.
Review by: Anonymous
Good quality
